A. Have a base mount
1. On the leather surface, punch the hole with a 3MM punch from the front:
2. Place the rivet's long nails on the base:
3. Attach the leather sleeve to the long nails:
4. Put a short cap on the leather:
5. Use rivet mold to the short cap, beat the mold with a hammer, preferably in place, the strength is big.
B. Demonstration of a cushion thick skin installation method:
1. On the leather surface, punch the hole with a 3MM punch from the front:
2. Place the rivet on a thicker piece of leather (if a hard skin is a better choice)
3. Cover the leather with the long nails:
4. Install the rivet Cap:
5. Use rivet mold to the short cap, beat the mold with a hammer, preferably in place, the strength is big.
C. How to install the following cushion punch PLATE:
1. On the leather surface, punch the hole with a 3MM punch from the front:
2. Place the rivet's long nails on the punching plate:
3. Attach the leather sleeve to the long nails:
4. Put a short cap on the leather
5. Use rivet mold to the short cap, beat the mold with a hammer, preferably in place, the strength is big.
